Category Archives: Setting up shop

Thoughts on order

[A combination of health problems and bereavement have conspired against me getting any time in the workshop (or even at car boot sales! 😦 ) but here’s a post I’ve been writing for a while] I suspect I’m not alone … Continue reading

Posted in Hand tools, Jigs Fixtures & Appliances, Machinery, Power tools, Projects, Purchases, Setting up shop, Tools, Workbenches, Workshop | Tagged , , , , , , , , | 2 Comments

Mounting metalwork vices – Part 2

Today being Fathers day I was able to get some time in the workshop to progress the vice bases. Last time I found that using glue as well as pocket hole screws made accurate placement quite difficult, as the glue … Continue reading

Posted in Setting up shop, Tools, Vices, Workshop | Tagged , , , , , , , , | 3 Comments

Mounting metalwork vices – Part 1

Today I made a start on building some bases for my two metalworking vices. The intention is that each base will have a cross member underneath which can be clamped in the woodworking vice on my larger bench. They’ll also … Continue reading

Posted in Setting up shop, Tools, Vices, Workshop | Tagged , , , , , , , , , , , , , , | 2 Comments

More offcuts

Yesterday after visiting my relative I went to Wenban’s to check out their offcuts. As usual they had a whole load of Pine, Iroko, Idigbo, Utile etc plus a few bits of Oak, Ash, Beech, Tulip etc.

Posted in Purchases, Setting up shop, Wood | Tagged , , , , , , , , , , , , , | 7 Comments

Aggravated plastic butchery

I’ve been wanting a way of derusting long tools and plane bodies for a while. I couldn’t find a suitable trough, but I read somewhere about using plastic pipe, blocked at one end. Today I went to a local builders … Continue reading

Posted in Restoration, Setting up shop, Tools | Tagged , , , , , , , , , , , , , , , , , , | 2 Comments

More reshuffling

After finishing off the drill press stand, I tucked the power tool table behind it, the folding workbenches beside it, rearranged the contents of its shelves and cleared off the top of the chest of drawers so it can hold … Continue reading

Posted in Setting up shop, Wood, Workshop | Tagged , , , , , , , , , , , , , , , , , , , | Leave a comment

Finishing off the bench drill stand

This morning I reconfigured the base of the drill press stand, moving the castored wheels to the back. Instead of rotating all the corner sections round 90 degrees, I only moved the castored ones round, left one of the fixed … Continue reading

Posted in Bench drill stand, Setting up shop, Workshop | Tagged , , , , , , | Leave a comment